Thompsonville IL AC and Heating Experts

Furnace Estimate Customer wanted to see if the current system and setup could handle the addition. Due to the set up of the house and duct work, another system maybe the best option. Pete will come back out, take measurements, and give customer options.

AC Maintenance PCSA 2024 AC Check Up Renewal Completed cooling maintenance, cleaned coil, flushed drain, replaced filter, checked system operation and found no issues, made sure system is working properly System is cooling at this time

Customer will let us know when to schedule work. Needs 1/2 hp 1075 240 12/12 motor replaced customer paid in full with cash

Replaced missing transformer, eliminated low volt short, and adjusted sagging coils causing stuck on heater. Furnace heating at this time

Estimate for a furnace installation

Upon arrival condenser coil was dirty, after cleaning condenser coil found unit low on refrigerant, charged unit with two pounds of 410a, found leak in evaporator coil in the attic, talked to customer about replacing evaporator coil and she wants to have a new coil ordered, air handler insulation is starting to fall off and will need to be readjusted when we come back to replace coil. System is cooling at this time

Inspected crossover, coil and blower. Crossover looks great, coil is damaged and blower wheel is dirty. When install is done, we need to pull and clean the blower motor

Estimate for a new air conditioning system

Air Conditioning Repair Complaint unit freezing up. System was low on R-22. Customer wants a new AC system and will call to set up an appointment for an estimate.

2023 PCSA A/C Maintenance. All operations checks good. Replaced filter, cleaned condenser, flushed drain.

Inspect ductwork. Duct appears to be insulated with no holes or issues. All runs are flex duct and insulated. Recommended customer closes vents and door to crawl space in winter to help lower electric bills. Inspected insulation in attic above living room. There is at least 7 to 8 inches of fiberglass which is within recommended range. Indoor coil needs cleaned. Air handler isn’t getting enough air flow from 1 inch filter in living room. Recommend customer installs an airbear cabinet and fitting above unit to help improve air flow through system. This should greatly help the system run more efficiently. Also recommended customer removes at least 1/2 of flooring in front of air handler to help remove blower door when needed. 3/30/23 Cleaned evap coil and installed fitting above air handler. Checked systems in both heat and ac mode. System appears to be operating normally at this time. Recommend customer gets check up on AC later this season to clean outdoor coil.

Unit running fine, very small furnace but it’s doing it’s best, need to come by with a 14x20 filter and clean the coil 2/20/23 returned and replaced filter, brushed and vacuumed coil, airflow is adequate

Complaint No Heat Can’t make a move without guessing at this time. Temp rise is good, filter is clean, sequencer and heat strips operating, blower and relay operating, capacitor is good. Took temps with door on and off and closet door open and shut. Checked airflow at all vents. Electrical looks good. Only thing I could think of is if there is some kind of duct issue. But we will have to schedule a duct inspection to rule that out. Unit heating at this time. In the hour I was there it came up 5 degrees.

Found tripped breaker and bad sequencer. Breaker not proper size to equip full capacity of current equipment. Tenant believes it has been keeping up with one heat strip in past. Unequipped 5 kw. #6 still not working right. Probably needs cleaned

Replaced heater package and checked system operation. Blower capacitor was almost dead. Replaced it and system is operating normally at this time.

PCSA 2022 Heating Check Up Renewal Checked air temps in heat pump and electric heating mode, replaced filter, flushed drain electrical compartment door was not accessible due to drain line on the way Checked compressor and outdoor fan amps, checked capacitor, made sure system is working properly System is heating at this time

System only has between 5 and 7.5 kw heat in operation. Filter is clean, thermostat batteries are new, and both heaters are coming on and going off as needed. Most likely cause of the issue is system is pulling in cool air from an outside source. Most likely location would be the vent in the living room. No air appears to be coming from it so it may have come detached. Informed customer they may want to cover that vent if it gets really cold outside. System appears to be operating normally at this time.

System only has 1 electric heater working. The porcelain base that secures the leads coming from the second electric heater have broke causing it to arc off the cabinet. Electric heat kit needs replaced.

Breaker was tripped due to a wire spade being burnt and coming loose. Replaced and verified operation of system. System is not running to full potential due to age, I would highly suggest having the heater kit replaced for a more safe and efficient way of heating.

Complaint: No Heat Recommended filter change. Problem is occurring in air conditioner mode. Equipment is operating. I put thumb gum in the hole where the thermostat wires come through to avoid sensor interference. Tenant has been told she needs to replace filter. Problem may be occurring but as of right now no issues found

NO AC - Nothing working at all . Bad transformer, had to relocate. Unit in very poor condition . Water heater in the way for most repairs.

AC Freezing Up . Added 2# R-22 stopleak

One time ac check up Replaced filter and dual run capacitor

Unit tripped on code 3, reset, monitored for 90 mins, readings are in a photo attached to job. Wired condenser fan directly to the contactor, will return in one week to check on system Replaced high pressure switch, performed 2022 summer pcsa, washed condenser, flushed drain changed filter everything is running great. Retired condenser correctly

Replaced high pressure switch. System is operating normally at this time. Customer will monitor for any changes in operation.